Advantages and characteristics

■ introduction

Good safety performance: no electrolyte leakage, battery expansion and rupture under normal use.

Good discharge performance: stable discharge voltage and stable discharge platform.

Good vibration resistance: in the fully charged state, the battery is completely fixed, vibrated at the amplitude of 4mm and the frequency of 16.7hz for 1 hour, without liquid leakage, battery expansion and rupture, and the open circuit voltage is normal.

Good impact resistance: the fully charged battery naturally falls from 20cm to 1cm thick hardwood for 3 times, without liquid leakage, battery expansion and rupture, and the open circuit voltage is normal.

Good over discharge resistance: at 25 ℃, the battery in fully charged state shall be discharged with constant resistance for 3 weeks (the resistance is only equivalent to the resistance required for 1ca discharge of the battery), and the recovery amount shall be more than 75%.

Good charging resistance: 25 ℃, fully charged battery 0.1CA, charging for 48 hours, no liquid leakage, no battery expansion and rupture, normal open circuit voltage, and capacity maintained at more than 95%.

Good high current resistance: the fully charged battery 2ca discharges for 5 minutes or 10Ca discharges for 5 seconds, and there is no fusing of the conductive part and no appearance deformation.

Technical

■LC series 12V Valve regulated sealed lead-acid batter

■Installation, use and maintenance

Battery connection

1. Batteries or battery packs with the same actual capacity can be used in series

2. Batteries or battery packs with the same actual voltage can be used in parallel

3. The connecting parts shall be tight to prevent sparks; In case of poor contact, the contact surface can be cleaned with soda water

4. The positive and negative poles shall not be reversed or short circuited

5. The batteries of the battery pack shall be separated by more than 10mm to facilitate heat dissipation

battery charging

1. Use of floating charge (limit voltage, control current): charging voltage 2.275-2.30v/single grid, temperature compensation, temperature compensation coefficient 3MV per unit (based on 20)

2. When trickle flow is used, the floating charge current of the battery is high-speed to less than 2mA / ah

3. Recycling (stop when fully charged and charge when fully discharged): charging voltage 2.35-2.45v/single grid

4. The maximum current shall not be greater than 25% of the nominal capacity

Note: the battery shall not be used in closed or high temperature environment, and shall be kept away from fire source

storage and installation

1. 1. If the battery is not put into use, remove the connecting wire, cover the pole sheath and wipe it clean

2. The battery shall be maintained and charged every three months. The charging method is current limiting and constant voltage method. The initial charging current is 0.1CA and the charging voltage is 2.4v/ single cell

3. The storage battery shall be stored in a dry and ventilated place, away from direct sunlight and heat source

4. When handling the battery, apply even force. The stressed part is the shell part of the battery to avoid operating the pole

5. Insulating tools shall be used during installation to prevent electric shock

Liruisi Company was established in 2007. At the beginning,the produced maintenance-free lead-acid batteries for high-end users around the world. After development, the product line expanded from a single battery to batteries, UPS uninterruptible power supplies, precision air conditioners and micro-module data center machine rooms. , to provide users with a full range of data center computer room products and solutions.

Liruisi has three major production bases located in Yangzhou, Jiangsu, Shangrao, Jiangxi and Shenzhen, Guangdong. Yangzhou and Shangrao specialize in the production of maintenance-free lead-acid batteries. The production capacity can be 2500WH per day, and the quantity is more than 3000 batteries per day. The Shenzhen factory is mainly responsible for the research and development and manufacturing of UPS uninterruptible power supply and micro-module data center. Headquarters and Global Sales Center.

In order to meet the needs of the national distribution network, Liruisi implements the multi-brand strategy of the main brand plus sub-brands. At present, it owns "LIRUISI, the main brand and LPSRITS, AROS, OLAND, YUPPIES, PILLER, IMV, MSF, National best-selling brands such as ENPOPT, AKC, Jiuneng, Outner, and Xiankong.

Adhering to the consistent philosophy of "stable technology, reliable quality, excellent cost performance, and good service" and the professional spirit of "continuous innovation and unlimited power", Li Ruisi is committed to becoming a cutting-edge brand of products in the global data center machine room.